National Wildfire Coordinating Group

Pump – Volume, Trash 2”

NFES Number: 
000683
Category: 
Small Engine Equipment
Updated: 
2017-05
Storage and Shelf Life Checks: 
Yes
Storage and Shelf Life Procedure: 
Date Last Tested (DLT) not to exceed 12 months.

Initial Inspection/Disposal Criteria

  1. Visually inspect for evidence of use (dust, oil, starter seal broken), damage or missing parts.
  2. Return to stock if there is no sign of use or damage and date last tested (DLT) does not exceed 12 months.
  3. Refurbish as necessary if unit has been used or fueled, damaged, or shelf life is exceeded.
  4. Dispose of the unit if it is not economically repairable.

Refurbishment Procedures

A. Cleaning

  1. Remove dirt and oil, using detergent or degreaser as necessary.
  2. Use pressure washer to remove heavy deposits of oil and grease.
  3. Equipment should be repaired and tested as quickly as possible after washing to minimize rust formation on metal parts.

B. Repair

  1. Check for loose and/or missing parts or mounting hardware; tighten or replace as needed.
  2. Check condition of engine oil, spark plug, air filter, and fuel filter; clean or replace as needed.
  3. Inspect exhaust system; make sure there are no cracks or leaks. Check for loose and/or missing parts and hardware, tighten or replace as needed.
  4. Ensure all decals (operations and warning) are affixed and legible.
  5. Ensure all gaskets on the pump fittings/adapters are in place and functioning properly.

C. Test for Performance

  1. Ensure recoil starter functions properly. Check for damage or fraying of pull cord; repair or replace as necessary.
  2. Engine should start easily, run smoothly, be free from fuel leaks, and provide sufficient power to the pump end.
  3. Ensure engine controls are operational and functional; stop switch, throttle and choke.
  4. Test for pump performance (see owner’s manual for specific performance data).
  5. Ensure pump packing or mechanical seal is not leaking, repair or replace as necessary.
  6. Should any function fail a test, refer to the manufacturer’s repair manual and troubleshooting guide to correct the problem.
  7. Remove all gasoline from fuel tank and run engine until carburetor is completely empty of gas.
  8. Remove all water from pump head.

D. Repackaging

  1. Use nylon “zip-tie” to tie off (seal) starter rope to the frame.
  2. Attach certification tag that indicates date last tested (DLT), property #, and name of individual certifying performance.
  3. Ensure that all identification (property #, serial #, owner ID) is affixed and legible.

 

Page Last Modified / Reviewed: 
2019-02-26