Skip to main content

PMS 448

PMS 448

Introduction

COVID-19 Refurb Guidelines

References

All Categories

Aviation

Camp

Clothing

Cordura

Fuel Handling

Kits

Medical

Miscellaneous

PPE

Small Engine Equipment

Tools

Water Handling

Deleted Items

Pump – Volume, Trash 3”

NFES #
001222
Category
Small Engine Equipment
Updated
Storage and Shelf Life Checks
Yes
Storage and Shelf Life Procedure
Date Last Tested (DLT) not to exceed 12 months.

Initial Inspection/Disposal Criteria

  1. Visually inspect for evidence of use (dust, oil, starter seal broken), damage or missing parts.
  2. Return to stock if there is no sign of use or damage and date last tested (DLT) does not exceed 12 months.
  3. Refurbish as necessary if unit has been used or fueled, damaged, or shelf life is exceeded.
  4. Dispose of the unit if it is not economically repairable.

Refurbishment Procedures

A. Cleaning

  1. Remove dirt and oil, using detergent or degreaser as necessary.
  2. Use pressure washer to remove heavy deposits of oil and grease.
  3. Equipment should be repaired and tested as quickly as possible after washing to minimize rust formation on metal parts.

B. Repair

  1. Check for loose and/or missing parts or mounting hardware; tighten or replace as needed.
  2. Check condition of engine oil, spark plug, air filter, and fuel filter; clean or replace as needed.
  3. Inspect exhaust system; make sure there are no cracks or leaks. Check for loose and/or missing parts and hardware, tighten or replace as needed.
  4. Ensure all decals (operations and warning) are affixed and legible.
  5. Ensure all gaskets on the pump fittings/adapters are in place and functioning properly.

C. Test for Performance

  1. Ensure recoil starter functions properly. Check for damage or fraying of pull cord; repair or replace as necessary.
  2. Engine should start easily, run smoothly, be free from fuel leaks, and provide sufficient power to the pump end.
  3. Ensure engine controls are operational and functional; stop switch, throttle and choke.
  4. Test for pump performance (see owner’s manual for specific performance data).
  5. Ensure pump packing or mechanical seal is not leaking, repair or replace as necessary.
  6. Should any function fail a test, refer to the manufacturer’s repair manual and troubleshooting guide to correct the problem.
  7. Remove all gasoline from fuel tank and run engine until carburetor is completely empty of gas.
  8. Remove all water from pump head.

D. Repackaging

  1. Use nylon “zip-tie” to tie off (seal) starter rope to the frame.
  2. Attach certification tag that indicates date last tested (DLT), property #, and name of individual certifying performance.
  3. Ensure that all identification (property #, serial #, owner ID) is affixed and legible.

 

Share on Social Media

Print PDF

NWCG Latest Announcements

NEW! S-390, Introduction to Wildland Fire Behavior Calculations (Blended) Available Now

Date: December 22, 2025
Questions about RT-130? 
Please contact: Fire Behavior Subcommittee

NWCG is excited to announce that the new S-390, Introduction to Wildland Fire Behavior Calculations (Blended) training is now available on the Wildland Fire Learning Portal.

This third course in the series combines online and instructor-led training components aimed at individuals who are involved in planning, managing, and executing wildland fire and prescribed burn operations; who require a thorough understanding of fire behavior calculations to enhance effectiveness and safety. This includes students who require the knowledge and skill necessary to perform the duties of a Type 3 Incident Commander (ICT3), Division/Group Supervisor (DIVS), or Prescribed Fire Burn Boss Type 2 (RXB2).

Students are required to be qualified as any Single Resource Boss position and complete the prerequisite S-290, Intermediate Wildland Fire behavior (Blended) course, before enrolling in S-390.

References:

S-390, Introduction to Wildland Fire Behavior Calculations (Blended)

Wildland Fire Learning Portal

NEW! S-320, Introduction to Incident Management Teams (Blended) Available Now

Date: December 18, 2025
Questions about RT-130? 
Please contact: Incident and Position Standards Committee

NWCG is excited to announce that S-320, Introduction to Incident Management Teams (Blended) is now available on the Wildland Fire Learning Portal!

This blended course combines online learning with instructor-led training, designed for individuals seeking to build leadership skills and gain experience in incident management.

Students are required to complete the prerequisite trainings ICS-100, Introduction to Incident Command System (ICS), ICS-200, Basic ICS for Initial Response, and ICS-700, An Introduction to the National Incident Management System (NIMS) prior to attending S-320.

References:

S-320, Introduction to Incident Management Teams (Blended)

Wildland Fire Learning Portal

New! Ransom Road WFSTAR Module

Date: December 16, 2025
Questions about RT-130? 
Please contact: NWCG Audiovisual Specialist

NWCG is excited to announce the release of the new Ransom Road Fire Module to RT-130, Wildland Fire Safety Training Annual Refresher (WFSTAR).

This module features a firsthand account from Rob Lee, official reports, and animated maps of the Ransom Road Fire which occurred on June 8, 1981, in Florida's Merritt Island National Wildlife Refuge.

The module is available now in NWCG's RT-130, WFSTAR Catalog.

References:

WFSTAR Catalog

Wildland Fire Lessons Learned Center

Call for Nominations: Paul Gleason Lead by Example Award

Date: December 11, 2025
Questions? Please contact:
 Leadership Committee 

Do you know someone working in wildland fire who strives to make positive change and is undeterred by obstacles or setbacks? Now is your chance to give that person the acknowledgment they deserve by nominating them for a Paul Gleason Lead by Example Award.

This award, is presented by the NWCG Leadership Committee to remember Paul Gleason's contributions to the wildland fire community and to recognize individuals or groups that exhibit the same spirit and dedication to leadership – those who lead by example.

Nominations can be submitted via email with an attached Lead by Example Form to BLM_FA_Leadership_Feedback@blm.gov or through the online form. 

Tips for successful nominations and more information can be found on the Lead by Example webpage. All nominations must be submitted by December 31, 2025.

References:

Paul Gleason Lead By Example Award 

Paul Gleason Lead by Example Award Nomination Form 2025 

Leadership Committee