Skip to main content

PMS 448

Pack – Fireline, Blue

NFES #
000678
Category
Cordura
Updated
Storage and Shelf Life Checks
None

Initial Inspection/Disposal Criteria

  1. Visually inspect fabric for cuts, tears, burns, and areas of abrasions. Inspect seams for breaks in stitching and for areas where the fabric is unraveling into the seams, check all straps and webbing for cuts or excessive wear.  Ensure straps are securely attached to the fabric; inspect zippers for broken coils and missing or broken sliders.  Ensure they are securely attached to the fabric. Open and close the zippers to ensure a smooth and proper function.  Ensure all hardware, buckles and Velcro closures are correctly attached.  Inspect all buckles and hardware for cracks or breaks.  Fasten and unfasten all buckles and hardware to ensure a smooth and proper function. Ensure all Velcro closures are securely attached. 
  2. Return to stock if item is clean, free of damage, and in unused condition.
  3. Refurbish if item passes inspection, and repair is economically feasible.
  4. Dispose of if there’s any indelible writing or markings on the item, or if item is beyond economical repair.

Refurbishment Procedures

A. Cleaning

  • CLASS 1 CORDURA (MACHINE WASH OK)
    • Allow any mud or loose dirt to dry then remove using a stiff-bristle brush. If stains remain, wash as recommended below.
    • Remove light oil and dirt stains by brushing with a solution of warm water and a mild detergent, rinse thoroughly, and hang to dry.  “Mild detergents” includes most home laundry detergents that contain no chlorine bleach or added scents.
    • For heavier oil or grease, soak in water-soluble biodegradable degreaser for at least 30 minutes, brush with a bristle brush, rinse thoroughly, and hang to dry.
    • If machine washing, use only cold water on a gentle cycle and air dry.
    • Where no other method is cleaning the fabric, wash with pressure washer set at wide fan, warm water, and only allow nozzle close enough as necessary for cleaning, the further away the better for the fabric.

DO NOT MACHINE DRY.  DO NOT USE BLEACH TO CLEAN FABRIC.

B. Repair

  1. If necessary, replace buckles and hardware.
  2. Repair any tears, holes or areas of excessive abrasion if economically feasible.
  3. Repair any seams that are worn or that have torn loose.
  4. Repair or replace webbing.

C. Test for performance

  • Test any buckles, zippers or Velcro that has been replaced for functionality.

D. Repackaging

  1. For NFES #000674, insert 2 blue canteen case and blue stuff sack into main compartment. Close all buckles, secure the shoulder yoke. Pack 10 packs per box.
  2. For NFES #001855, pack 10 packs per NFES #002030 carton (24” x 16” x 12”).
  3. For NFES #000744, pack 20 per local cache carton preference.

 

NWCG Latest Announcements

ETC/RMC Safety Bulletin: 25-001 New Guidance on Laundering Wildland Fire Clothing to Reduce Contamination

Date: Aug 8, 2025
Questions? Please contact:
Equipment Technology Committee
 Risk Management Committee

The Equipment Technology Committee (ETC) and the Risk Management Committee (RMC) have issued Safety Bulletin 25-001: Laundering to Decontaminate Wildland Fire Clothing. Recent research revealed that wildland fire flame-resistant pants and shirts can be contaminated with chemicals from combustion byproducts, including carcinogens, and that common laundering practices can effectively remove these harmful contaminants from wildland firefighter clothing more effectively than previously understood. It is recommended to decontaminate wildland fire clothing as frequently as possible. 

Frequently Asked Questions about this new information and how to implement recommendations can be found on the NWCG Alerts page. Read the complete ETC/RMC Safety Bulletin: 25-001 to learn more. 

References:

NWCG Alerts

ETC Safety Bulletin: 25-001

Frequently Asked Questions (FAQ) on Laundering to Decontaminate Wildland Fire Clothing

Equipment Technology Committee

Risk Management Committee

FAQ Now Available for Archiving Type 1 and Type 2 Incident Positions

Date: Aug 6, 2025
Questions? Please contact:
Incident and Position Standards Committee

To support the transition to Complex Incident Management (CIM), NWCG will archive all Type 1 and Type 2 Command and General Staff (C&G) position qualifications in January 2026, as outlined in NWCG Executive Board Memo 25-002. To assist with this transition, a new Frequently Asked Questions (FAQ) document is now available.

This resource answers common questions about the status of Type 1 and Type 2 qualifications, impacts to incident qualification management, training requirements, and resource ordering considerations. Review the full FAQ to learn more.

For additional information on CIM and the transition of C&G positions, see NWCG Executive Board Memos 23-005, 24-005, and 25-002, as well as the Incident Workforce and Development Group webpage.

References:

NWCG Type 1 & Type 2 Position Archiving FAQ

NWCG Executive Board Correspondence

Incident Workforce Development Group

Incident and Position Standards Committee

Incident Position Standards and the Next Generation Position Task Books Now Available for UASD, UASM, UASL and UASP

Date: July 31, 2025
Questions?  Please contact:
Interagency Fire Unmanned Aircraft Systems Subcommittee
 

NWCG is excited to announce that Incident Position Standards and the Next Generation Position Task Books are now available for all four Unmanned Aircraft Systems positions:

  • Unmanned Aircraft Systems, Data Specialist (UASD)
  • Unmanned Aircraft Systems, Manager (UASM)
  • Unmanned Aircraft Systems, Module Leader (UASL)
  • Unmanned Aircraft Systems Pilot (UASP)

The Performance Support Packages for these positions were developed as part of the Incident Performance and Training Modernization effort. These resources support trainees, qualified personnel, and evaluators in their respective roles.

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1, scheduled for January 2026.

References:

NWCG Unmanned Aircraft Systems, Data Specialist Position Page

NWCG Unmanned Aircraft Systems, Manager Position Page

NWCG Unmanned Aircraft Systems, Module Leader Position Page

NWCG Unmanned Aircraft Systems Pilot Position Page

Incident Position Standards and the Next Generation Position Task Books Now Available for RADO and INCM

Date: July 30, 2025
Questions?  Please contact:
Incident Logistics Subcommittee
 

NWCG is excited to announce that Incident Position Standards and the Next Generation Position Task Books are now available for Radio Operator (RADO) and Incident Communications Center Manager (INCM).

The Performance Support Packages for these positions were developed as part of the Incident Performance and Training Modernization effort. These resources support trainees, qualified personnel, and evaluators in their respective roles.

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1, scheduled for January 2026.

References:

NWCG Radio Operator Position Page

NWCG Incident Communications Center Manager Position Page