Skip to main content

PMS 411

PMS 411

Introduction

Fire Shelter History

Know Your Fire Shelter

Escape and Entrapment

Selecting Your Deployment Site

Deployment

During a Deployment

Training

Inspection and Care

After a Deployment

Project Reviews, Tech Tips, and Publications

Deployment Stories, Insights, and Reports

NWCG Standards for M-2002 Fire Shelters: Selecting Your Deployment Site

The characteristics of an effective deployment site have not changed. Your goal in selecting a deployment site is to keep the fire shelter away from heat, especially flames. Practice evaluating deployment sites so that you can recognize them quickly under stress. Identify effective sites whenever you are on the fireline so you know where they are before you need one.

A rocky mountain forest

1. Keep away from narrow draws, chutes, and chimneys. They tend to funnel smoke, flames, and hot gases that can damage your shelter.

A rocky mountain forest

2. Avoid saddles on ridgetops. They also funnel smoke and heat.


A dirt road in through wildland forest.

3. Flat areas on slopes, such as benches, or road cuts, offer some protection from radiant and convective heat. These level areas can keep you below the path of flame and convective heat. Do not deploy in the middle of a road if vehicles may be passing. A drainage ditch on the uphill side of a road cut can be an effective deployment site unless it contains fuels that could ignite and burn the shelter. Four firefighters deployed their fire shelters on this road during a burnover. All four survived with only minor burns.

A rocky mountain forest

4. Stay out of draws, even when deploying on a road.


Birds eye view of a smoke rising above trees in a forest
A rockslide with tall trees in the forefront
A rocky mountain forest.
5. Try to pick natural firebreaks such as wet meadows, wide streambeds, swampy areas, and rockslides.


A rocky mountain forest
A rocky mountain forest
6. Do not deploy in or next to tall or thick grass, small trees, trees with low branches, brush, piles of slash, or firefighting equipment such as packs, parachutes, tools, or chain saws. Firefighters have been burned because they deployed too close to such fuels. Large rockslides can be effective deployment sites, but you must stay away from brush and trees, and from fuels scattered in the rocks. Even though it can be difficult to hold the edges of the shelter down, large, jumbled rocks, rockslides sometimes offer the largest area free of fuels and may be the best option for deployment.


A rocky mountain forest

7. Ground fuels, such as grass, or tree litter, can ignite rapidly. Clear the deployment site to mineral soil if time allows. If time is critical, pick a site with the sparsest fuels.

A rocky mountain forest

8. Deploy fire shelters well away from thick vegetation such as the shrubby understory and trees.


A rocky mountain forest

9. Boulders, large rocks, buildings, vehicles, and equipment can provide buffers from the heat of the fire. Keep in mind that when vehicles, equipment, and buildings catch fire, they burn hot, and for a much longer duration than the vegetation around them. This can lead to shelters being exposed to heat for a prolonged period, well after the flame front has passed. This may keep firefighters in their shelters longer, exposed to prolonged levels of dangerous heat.

A rocky mountain forest

10. Avoid areas where rocks or logs can roll on you or snags can fall on you.


A rocky mountain forest

11. The lee side of a ridgetop can be an effective deployment site because the flames and hot gases tend to rise above the ridge. Fire intensity usually drops when fire reaches a ridge. But be alert for the possibility that firebrands might ignite fires below you on the lee side of the ridge.

A rocky mountain forest

12. Burned-out areas can be effective deployment sites if there is no fuel left to reburn. Be aware of residual heat and hotspots on the ground. Scrape the ground if possible to clear away any heat and burning materials. Burn injuries have occurred from firefighters deploying in the black that was still hot.


A rocky mountain forest
A rocky mountain forest
13. Wide areas that have been cleared of fuel, such as dozer lines or roads, can be good deployment sites, depending on the size of the area that has been cleared and the behavior of the fire.

 

A rocky mountain forest
A rocky mountain forest
14. Bodies of water can be adequate deployment zones, however you should be aware of several hazards if you find yourself having to use a body of water. Deployments can last from several minutes to an hour or more. If the water is over your head in depth, you may be at higher risk of drowning especially once your boots and clothing become waterlogged. Since water removes heat from the body much faster than air, you may be at risk of hypothermia from deployments in bodies of water. If there is a current to the water your fire shelter may be hard to hold on to or you may become entangled in your shelter and drown. The fire shelter’s ends can fill with water and become very heavy. For further information read this tech tip on deploying in bodies of water.

 

 
˂˂ Previous Chapter
 
Next Chapter ˃˃
 

Print PDF

NWCG Latest Announcements

Leadership Committee IAP Flyer Now Available

Date:  May 8, 2026
Questions? 
Please contact: Leadership Committee

The NWCG Leadership Committee promotes and enables leadership development across the wildland fire service. The committee provides education, training opportunities, and support for leadership innovation and best practices throughout the community.

A new IAP flyer is now available on the committee website, offering an overview of the products, curriculum, and learning opportunities the Leadership Committee develops. This resource is ideal for posting in your office, sharing with new employees, or distributing through your incident management teams to engage new voices in the leadership journey and reinforce a culture of self‑reflection, development, and growth.

References:

Leadership Committee 2026 IAP Flyer

Incident Operations Subcommittee Updates the Next Generation Position Task Book for FFT1

Date:  May 7, 2026
Questions? 
Please contact: Incident Operations Subcommittee

The NWCG Incident Operations Subcommittee (IOSC) has updated the NWCG Position Task Book for Firefighter Type 1 (Squad Boss) (FFT1), PMS 311‑14. The FFT1 Position Task Book transitioned to the Next Generation (Next Gen PTB) format in June 2025 through the Incident Performance and Training Modernization effort. Since then, IOSC has received feedback from the wildland fire community regarding coding for one of the tasks. Task #13 has been updated to include the option of evaluation in a simulation.

See IOSC Memorandum 26‑01: Transition Plan for Implementation of Updates to the NWCG Position Task Book for Firefighter Type 1 (Squad Boss) (FFT1), PMS 311‑14 for more information.

References:

IOSC Memorandum 26-01: Transition Plan for Implementation of Updates to the NWCG Postion Task Book for Firefighter Type 1

NWCG Firefighter Type 1 Squad Boss Position Page 

NEW! S-212, Intermediate Faller (Online) Course Available Now 

Date:  April 23, 2026
Questions? 
Please contact: Hazard Tree and Tree Felling Subcommittee

NWCG is pleased to announce that the new S‑212, Intermediate Faller (Online), course is now available on the Wildland Fire Learning Portal (WFLP). This second course in the series provides students with the knowledge and skills required to perform the duties of an Intermediate Faller (FAL2), as described in the FAL2 Incident Position Description. This course is intended for individuals seeking to advance from Basic Faller (FAL3) to FAL2.

S‑212, Intermediate Faller is a fully online, self‑paced training program consisting of 13 units. Learners will engage with interactive, scenario‑based content designed to progressively build foundational skills and knowledge essential for the FAL2 role.

Students must be qualified as a Basic Faller (FAL3) prior to enrolling in S‑212, Intermediate Faller course.

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1, scheduled for January 2027.

References:

S-212 Intermediate Faller (Online)

RMC Memo 26-01: Transition Plan for Implementing Updates to Intermediate Faller (FAL2) Position Qualifications

Intermediate Faller (FAL2) Position Page

NWCG Standards for Wildland Fire Chainsaw Operations, PMS 212

New Aircraft Flight Schedule Form, PMS 249

Date:  April 17, 2026
Questions? 
Please contact: National Coordination System Committee

A new publication from the National Coordination System Committee (NCSC) is now available. The NWCG Aircraft Flight Schedule Form, PMS 249, will be used for aviation crews and dispatch to share flight information that is needed for resource tracking, and if needed, for emergency procedures.

For further details, please contact your NCSC representative. 

References:

NCSC Memo 26-01: Implementation of NWCG Aircraft Flight Schedule Form, PMS 249

NWCG Aircraft Flight Schedule Form, PMS 249