Skip to main content

Fire Shelter Deployment

 

Firefighters must never rely on fire shelters. Instead, they depend on well-defined and pre-located escape routes and safety zones. However, if the need for shelter deployment should ever arise, it is imperative that firefighters know how to deploy and use the fire shelter.

  • Do not think of your fire shelter as a tactical tool.
  • Recognize when deployment is your only option. When considering escape, remember that you can hold your breath for only about 15 seconds while running through flames or superheated air.
  • If time runs out while attempting to escape, get on the ground before the flame front arrives and finish deploying on the ground. Death is almost certain if the fire catches a person upright (the optimal survival zone with or without a shelter is within a foot of the ground). Once entrapped, the highest priority is to protect the lungs and airways.
  • When deploying, remove packs and place them away from the deployment area.
  • Even though deploying your shelter is a last resort, time is critical when entrapped. Play it safe – give yourself ample time to deploy. Failure to adequately anticipate the severity and timing of the burnover and failure to utilize the best location and proper deployment techniques contributed to the fatalities and injuries on the Thirty Mile Fire. Don’t let the cost of opening a shelter become a factor in your decision.
  • Before passing through superheated gases, try to close the front of your shroud. You can also take your shelter out of the plastic bag and use it as a heat shield to pass quickly through a hot area. If you use the shelter in this way, do not drop it or allow it to snag on brush. Remember that your lungs are still vulnerable.
  • If flames contact the shelter, the glass/foil fabric heats up more rapidly. If flame contact is prolonged, spots of aluminum foil can melt or tear away, reducing protection. Even if this happens, it is still safer inside the shelter. Your flame-resistant clothing becomes your backup protection. It is even more critical to keep your nose pressed to the ground and stay in your shelter.
  • Remember, direct contact with flames or hot gases is the biggest threat to your shelter. It is vital to deploy in a place that offers the least chance of such contact. The heavier the fuels, the bigger your fuel break should be.
  • Remember, once you commit yourself to the shelter, stay there. No matter how bad it gets inside, it is usually much worse outside. If you panic and leave the shelter, one breath of hot, toxic gases could damage your lungs. Suffocation may follow. In entrapment situations, most firefighters are killed because of heat-damaged airways and lungs, not external burns. Protect your airways and lungs at all costs by keeping your face close to the ground and staying in your shelter.

If your crew becomes entrapped, identify everything you and your crew/team are going to do to survive. Start your discussion using the Last Resort Survival in the Specific Hazards section (gray) of your  Incident Response Pocket Guide (IRPG), PMS 461.

Activity:

Consider having a mock fire shelter deployment exercise in realistic terrain and fuels using practice shelters (no live fire). Assess the exercise using an After Action Review (AAR).

Also See: Fire Shelter Deployment Site Selection

 

6MFS Suggestion Form


Have an idea or feedback?

Share it with the NWCG 6MFS Subcommittee
 


Follow NWCG on X and Facebook
 


 

Last Modified / Reviewed:

NWCG Latest Announcements

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

Date: June 3, 2025
Questions?  Please contact:
Emergency Medical Committee

The Emergency Medical Committee has issued interim guidance for Rapid Extraction Module Support (REMS) teams. Until further notice, Type I and II REMS teams must designate a team leader qualified at Firefighter Type 1 Squad Boss (FFT1) or higher. This temporary change replaces the Single Resource Boss (SRB) requirement, which is currently not feasible due to administrative barriers.

This memorandum does not include any other changes to the NWCG Standards for Rapid Extraction Module Support, PMS 552. This interim change takes effect immediately and will remain in place until further notice.

References:

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

NWCG Standards for Rapid Extraction Module Support, PMS 552

Equipment Bulletin 25-002: Chaps, Chain Saw, M-2020, Nonconformities Affecting Use, Appearance, and Serviceability

Date: June 2, 2025
Questions?  Please contact:
Equipment Technology Committee

The Equipment Technology Committee issued Equipment Bulletin: 25-002 to address a manufacturing nonconformity affecting Forest Service specification, 6170-4K Chain Saw Chaps. The issue applies to chaps manufactured in 2024 and 2025 and distributed through FedMall. These chaps may have incorrectly bound edges that expose inner protective layers.

Independent purchasers should inspect all chain saw chaps received from FedMall beginning in 2024, prior to use. Review the full Equipment Bulletin: 25-002 for inspection criteria and recommended actions.

References:

NWCG Alerts

ETC Equipment Bulletin: 25-002

2024 Wildland Fire Emergency Medical Service Awards

Date: May 22, 2025
Questions?  Please contact:
Emergency Medical Committee

The NWCG Emergency Medical Committee (EMC) is proud to announce the recipients of the 2024 Wildland Fire Emergency Medical Service Awards. Each year, EMC recognizes individuals and groups who have demonstrated exceptional actions or accomplishments that go above and beyond their normal mission or job duties.

Congratulations to all the awardees and nominees. Through leadership and initiative, they have made significant contributions to the safety and well-being of the wildland fire community. These honors are well deserved.

References:

2024 Wildland Fire EMS Awards

NWCG Emergency Medical Committee

NWCG Welcomes the Incident Management Teams Association as an Associate Member

Date: May 21, 2025
Questions?  Please contact:
https://www.nwcg.gov/contact-us

The NWCG Executive Board is honored to announce that the Incident Management Teams Association (IMTA) has joined the National Wildfire Coordinating Group as an associate member.

IMTA is a dedicated group of incident management professionals committed to enhancing the profession by promoting standards and fostering collaboration across federal, state, local, Tribal, and private sector partners throughout all phases of incident management.

“Joining NWCG aligns with our mission to elevate incident management professionals nationwide,” said Dr. Randal Collins, President of IMTA. “This is a proud moment for all of us committed to advancing public safety.”

References:

Incident Management Teams Association

National Wildfire Coordinating Group